Drop tower testing is a form of impact testing used to measure energy absorbed by a material during high velocity impacts. The test system consists of a falling mass guided by two columns, instrumentation to measure force, fixture to hold the sample, and data collection system. This test is used for a component or an assembly.
Major uses are for assessing automotive components like energy absorbers, frontal collision behavior, side impact collision, etc. Other uses include assessing shatter resistance of coatings on materials, puncture resistance of fabrics, axial collapse behaviors of columns and pipes, delamination behaviors of woven fiber composites and laminates.
The test does not require much preparation unlike other standard tests except that this must be fixtured so that when the hammer falls it is in the same direction as it would experience loading in service. For example, testing pipes and tubular components the sample may be positioned with the tube axis parallel to the hammer falling direction. If a side impact is required the tubes may be positioned with the axis normal to the hammer.
Capability – At TTL, we have a 20’ tall vertical drop tower with 132 Lbs weight for testing large metallic components and assemblies (See figure). The larger hammer is instrumented so that collision forced can be measured. In addition, we have a smaller bench scale unit for assessing shaper resistance of coating, puncture resistance of fabrics, delamination of laminates and composites. The tests are generally conducted at ambient condition. If non- ambient conditions, such as low temperatures, are required we can engineer a system to test at low temperatures.
Typical standards used:
Product testing generally refers to testing finished products before being shipped to customer or consumer. It differs from material testing in that an additional aspect of product geometry, product surface, etc., their influence on the product performance is tested. Some well-known examples of product testing are automotive crash testing to assess crash worthiness of the… Continue Reading
Touchstone is committed to providing its customers with quality, reliable test results. That is why we have undertaken the rigorous steps needed to meet and secure the most stringent of test lab accreditations including ISO/IEC 17025, NADCAP 7101 (Materials Test Lab) and NADCAP 7122-I (Non-Metallics Materials Testing).